11/30/2023 0 Comments Hp photosmart 6510 ink streaksMake sure the ribbon cables are tight and put them back in so they don't get pinched by the cover or get in the way of any moving parts. Remove any excess water tha has dropped into the base of the printer with paper towels. I suggest you finish up with a paper towel. Keep doing this until you have very little black ink on the swab, cotton balls or paper towel. Gently (I mean gently) rub from side to side. If you decide to use the latter two methods, dip either in the hot water and then press it up against the printhead by curling one of your fingers. You can also use a thick paper towel such as Bounty. You can also perform this operation with cotton balls (be careful you don't leave any strands of cotton on the printhead!). Dip the swab into the water and rub the swab back and forth over the printhead. You can bend cotton swabs slightly more than 90 degree so the swap points upward. Put on a pair of rubber glove (the kind for washing dishes), unless your tough and can stand the pain of hot water. Slide the print head to the right leaving enough room for your fingers to fit around it to the right and under the it. Heat the water so it is as hot as you can and still touch it without scalding yourself. Heat some distilled water (or regular water if you don't live in a hard water area). Carefully move the access cover to the side as far as you can without pulling off the ribbon cables (if they do come off, you can just push them back in). Now remove the top access panel to the printer by gently pulling up - you need to be careful here because of the two ribbon cables that connect to the LCD panel and the red and black wires that attach to the switch. Remove the remaining two screws by the top cover hinges.Īfter you remove those screws gently lay down the top cover. You may need to hold it whil removing the remaining two screws. Be careful the top cover doesn't fall backward. It will pop off and then you will have access to the screw. You need to grab the hinge and while holding the top cover, gently but firmly pull the hinge toward the front of the printer. There is one screw behind the hinge on the right side of the printer. Remove the two screws behind the LCD panel (just pick up the panel so it is completely vertical). Remove all of the printer cartridges and put them aside. Now unplug the power cable (you need to have the printer head movable) The printer should be powered on so the printhead will not be locked down. Lift the cover as if you are going to replace the printer cartridges. You have to remove 8 screws that hold on the top cover. You can clean the black printhead on the Photosmart 6510. Sorry I'm late to the party, but I just experienced the same problem and there is a fix (although it can get a little messy). But I called HP and they suggested I upgrade to a newer printer.for a fee! The printer is fine! Made me really, really angry.:catsad: I subsequently was able to reattach the cables, but I'm still wrote: My LCD came disconnected during shipment (I moved), but I was at loss as to how to get them back in. While this isn't my problem, I was intrigued by the part about the ribbon cables and the LCD. Business PCs, Workstations and Point of Sale Systems.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |